Body and Sheetmetal Restoration Discussion.
4 posts • Page 1 of 1
- Tire Kicker
- Posts: 30
- Joined: Mon Sep 1st, 2003 3:56
- Plymouth: Special_Deluxe_Convertible_Club_Coupe
- Location: Freedom, Pa
My stainless is pretty dull. The rocker pieces are pretty well pitted and some rust. Does anyone have a suggestion on how to bring them back?
- Deluxe Member
- Posts: 298
- Joined: Tue Sep 2nd, 2003 7:12
- Plymouth: Special_Deluxe_Station_Wagon
- Location: new bedford,mass
There are two ways to restore stainless trim. You could bring it to a chrome and polishing outfit which can get pricey, or you can invest in some materials and do it yourself. You will need a buffing motor. These are either mounted to a workbench or on a stand that is floor mounted. You'll also need buffing wheels and assorted buffing compounds made just for stainless. The Eastwood company sells all the stuff needed for all kinds of metal polishing. You can check them online and maybe also do a search to see who else carries the supplies.Polishing is not that difficult, but hammering out dents in stainless is something else. Eastwood also has books on restoration of auto trim.
- Flathead Fixer
- Posts: 59
- Joined: Sun May 30th, 2010 1:51
- Plymouth: Special_Deluxe_4dr_Sedan
What did you end up doing with the stainless trim? I see it has been a few years. I have a right front stainless fender trim that is pretty dented. I have never seen restored stainless or if I have I wasn't aware of it.
- Posts: 879
- Joined: Mon Nov 4th, 2002 3:59
- Plymouth: No_Plymouth
- Location: Northern Colorado
Stainless can be restored fairly easily if you are patient. Several folks provide the service. Essentially they use a small very smooth anvil and small hammers to remove the dents and then buff the stainless smooth and shiny!
Users browsing this forum: No registered users and 1 guest